Planetary Gearmotor Stepper Motor with Encoder Maximum Torque: 4.5 NM
Planetary Gearmotor Stepper Motor Holding Torque with Encoder: 1.5 NM
Planetary Gearmotor Stepper Motor with Encoder Current: 5.8 Amps
Planetary Gearmotor Stepper Motor with Encoder Flange: 57X57 mm
Stepper Motor Reduction with Encoder Planetary Gearbox: 1:5
Planetary Geared Stepper Motor with Encoder Length: 150 mm
Planetary Gearmotor Stepper Motor Cable with Encoder: 3 pcs

57BHP80-580A-08Mp(PL5K)-Step Motor 3D Model Download

Planetary Geared Stepper Motor with Encoder 57BHP80PlanetaryGeared Stepper Motorwith Encoder57BHP80

Encoder Gearmotor Stepper Motor Connecting Settings YELLOW U BLUE V BLACK W The most feared step miss in stepper motors is solved by using a closed loop system in this series. The 1000 pulse encoder disk and reader behind the motor informs the driver whether the motor is taking the steps it should take or not. The driver boosts the motor by increasing the amperage for the steps it cannot take. If there is still a step it cannot take, it stops by turning on the alarm. It is preferred because it can respond much faster (close to servo) to sudden stop-start compared to stepper motors, and the position is guaranteed by monitoring the alarm output. Compensates for missed pulse (backup). It returns to the missed position. In addition, since the holding torque has a locking feature like stepper motors, they are systems that take the lead in position protection. It does not require position tracking by following the encoder output. It is fixed with our experience so far that it is in full position as long as there is no alarm. IMPORTANT REMINDERS Jumper settings must be made when the drive is off for safety. The metal part of the panel where the drives are located must be grounded. (The need for grounding can be understood by connecting a voltage measuring device to the neutral and ground cables.) In PLC, Arduino, Axis control card or specially designed cards, PULSE and DIR signals must be sent as 5V. If the PULSE and DIR signals to be distributed individually in minus (NPN) or plus (PNP) driving are above 5 volts, a resistor must be entered. Example 1.8KΩ for 24Volt.

Encoder Cable Pin numbers

	Color of the wire	function
3pin	white	EGND
2pin	red	VCC
13pin	blue	EA-
1pin	black	EA+
12pin	green	EB-
11pin	yellow	EB+