Stepper Motor Driver 3CW2283

Stepper Motor Driver Voltage: 150VAC~220VAC

Stepper Motor Drive Current: 2.0AMPER~8.3AMPER

Stepper Motor Driver Nema: Nema 42, Nema 52

Stepper Motor Driver Phase : 3 Phase;

Product Code: Stepper Motor Driver 3CW2283

3 Phase STEP MOTOR DRIVE 3CW2283;

• Jumper settings should be made with the driver off for safety.
• In ampere settings, the ampere of the motor will be matched to the RMS setting of the driver.
• The metal part of the panel where the drives are located must be grounded. Before giving amperes to the drives, voltage control must be done by entering a measuring device between NEUTRAL and EARTH cables. The ideal situation is zero volts.
• In PLC, Arduino, Axis control card or specially designed cards, PULSE and DIR signals must be sent as 5V. In devices with signal outputs above 5 volts, resistance should be entered into the PULSE and DIR signal output cables to be distributed individually in minus or plus driving. For example, the resistance required for 24Volt output is 1.8KΩ.

Stepper Motor Driver 3CW2283 Product Video