Stepper Motor Driver M542

Stepper Motor Driver Voltage: 24VDC~50VDC

Stepper Motor Driver Current: 1.5AMPER~5.6AMPER

Stepper Motor Driver Nema: Nema 17, Nema 23, Nema 34

Stepper Motor Drive Phase: 2 Phase

Product Code: Stepper Motor Driver CWD556

Click to ReviewStepper Motor Driver CWD556

You can download the datasheet file by clicking on the product code.

2 Phase Stepper Motor Driver M542

• Jumper settings should be made with the inverter off for safety.
• In amperage settings, the amperage of the motor shall be matched to the RMS setting of the driver.
• The metal part of the panel where the drives are located must be EARTHED. Before giving amperes to the drives, voltage control must be done by entering a measuring device between NEUTRAL and EARTH cables. The ideal situation is zero volts.
• In PLC, Arduino, Axis control card or specially designed cards, PULSE and DIR signals must be sent as 5V. In devices with signal outputs above 5 volts, resistance should be entered into the PULSE and DIR signal output cables to be distributed individually in minus or plus driving. For example, the resistance required for 24Volt output is 1.8KΩ.

Stepper Motor Driver M542 Product Video