Your shopping cart is empty!
Quantity / Size
YELLOW A-
BLUE A+
BLACK: B+RED
: B-
The most feared step miss in stepper motors is solved by using a closed loop system in this series. The 1000 pulse encoder disk and reader behind the motor informs the driver whether the motor is taking the steps it should take or not. The driver boosts the motor by increasing the amperage for the steps it cannot take. If there is still a step it cannot take, it stops by turning on the alarm. It is preferred because it can respond much faster (close to servo) to sudden stop-start compared to stepper motors, and the position is guaranteed by monitoring the alarm output.
IMPORTANT REMINDERS Drive Jumper settings must be made with the drive switched off for safety. The metal part of the panel where the drives are located must be grounded. (The need for grounding can be understood by connecting a voltage measuring device to the neutral and ground cables.) In PLC, Arduino, Axis control card or specially designed cards, PULSE and DIR signals must be sent as 5V. If the PULSE and DIR signals to be distributed individually in negative (NPN) or positive (PNP) driving are above 5 volts, a resistor must be entered. Example 1.8KΩ for 24Volt.
Color of the wire
function
3pin
white
EGND
2pin
red
VCC
13pin
blue
EA-
1pin
black
EA+
12pin
green
EB-
11pin
yellow
EB+
86BHH76-380p-40Mp - Stepper Motor 3D Model with Encoder Download
İlgili Ürünler
Hybrid Servo Drive CWDS86C Hybrid Servo Drive Voltage: 20VAC~90VAC OR 30VDC~110VDC Hybrid Servo Drive Current: 8.0 AMPER Hybrid Servo Drive: 2 Phase Servo DriveProduct Code:Hybrid Servo Drive...
Hybrid Servo Drive SS1108 Hybrid Servo Drive Voltage: 70VAC~130VAC Hybrid Servo Drive Current: 8.0AMPER Hybrid Servo Drive: 2 Phase Servo DriveProduct Code:Hybrid Servo Drive SS1108 Motor ...
Reviews (0)
Write a review