Bottom Supported Shaft, Chrome-Plated Induction Hardened Millers, Mechanical Products
Chrome-Plated Hardened Shaft SFC 10
SKU: SFC 10$7,00
Chrome-Plated Induction-Hardened Ground Shafts
Chrome-plated induction-hardened shafts are manufactured from CK 55 material and have a surface hardness of 62+/-2 HRC. In particular, low surface hardness in linear bearing applications (55 HRC piston shaft, only non-chrome-plated induction-hardened shafts, mercury steel, etc.) causes scratching on the shaft. This results in the bearing not being able to operate on a clean surface and failing prematurely. The middle section of the shafts has normal hardness, and it is possible to reach the normally hard body by cutting teeth in the middle or removing chips from the hard outer surface. Additionally, SK series or SHF series aluminum bearings can be used for shaft bearings.
Based on 0 reviews
Be the first to review “Chrome-Plated Hardened Shaft SFC 10”
Related products
-
Mechanical Products, Linear Rail Car SHN B Series, Linear Slide Rail Cars
Linear Slide Linear Rail Carriage SHN 45 B
Mechanical Products, Linear Rail Car SHN B Series, Linear Slide Rail CarsLinear Slide Linear Rail Carriage SHN 45 B
LINEAR RAIL CAR TECHNICAL SPECIFICATIONS Height Including Rail 70 mm Hole Center Width x Length 60×60 mm Total length 139.40 mm All Width 86 mm Static Load Capacity 155.93 kN Dynamic Load Capacity 77.57 kN Rail Hole Center to Center 105 mm Rail Base Width 45 mm SKU: SHN 45 B -
Mechanical Products, Linear Rail Car SHN B Series, Linear Slide Rail Cars
Linear Slide Linear Rail Carriage SHN 25 B
Mechanical Products, Linear Rail Car SHN B Series, Linear Slide Rail CarsLinear Slide Linear Rail Carriage SHN 25 B
LINEAR RAIL CAR TECHNICAL SPECIFICATIONS Height Including Rail 40 mm Hole Centre Width x Length 35×35 mm Overall length 84 mm All Width 48 mm Static Load Capacity 56.19 kN Dynamic Load Capacity 26.48 kN Rail Hole Center to Center 60 mm Rail Base Width 23 mm SKU: SHN 25 B
There are no reviews yet.